Establish an overrun dynamic fine inspection system based on
computer network to automatically monitor illegal and out of gauge
transportation of vehicles, realize 24-hour freight vehicle
transportation monitoring, form a powerful deterrent, focus on
solving the three major problems of shortage of overload control
staff, difficulty in obtaining evidence, and safety of overload
control, and reduce the rate of out of gauge vehicle
transportation.
1. Weighing accuracy
The number of axles, axle load, gross weight of vehicle and cargo,
license plate, speed and other information can be measured timely
and accurately without stopping, decelerating, driving at a
specific speed and in a specific lane. The accuracy is not lower
than the national level 5 standard. The vehicle can pass the
verification with a type evaluation certificate.
2. Weighing speed adaptability
In order to avoid the detection of off-site law enforcement
weighing system, illegal vehicles that exceed the limit often cheat
by using super low speed over weighing, high speed post punching
and other behaviors. The bidding products can accurately detect the
following behaviors, and the accuracy reaches level 5:
1) Be able to weigh accurately when the vehicle is over balanced at
super low speed or running and stopping, that is, be able to weigh
vehicles of the speed cutoff type (intermittent driving);
2) It can accurately weigh when the vehicle passes at high speed,
that is, the maximum detection speed of dynamic weighing reaches
100km/h;
3. Full width pavement seamless detection
It is very common for highway vehicles to cross the lane or drive
against the lane line during normal driving. In order to avoid
detection, out of gauge vehicles will deliberately use the method
of low-speed edging and pressing the sensor seam to drive, so that
part of the tires leave the weighing carrier, making the data
inaccurate to avoid detection. The weighing equipment can
accurately weigh the vehicles that cross the lane and the vehicles
that press the line, with the error not exceeding ± 5%.
Product Parameters
